♥♥ 2017 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 400-201 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
400-201 Product Description:
Exam Number/Code: 400-201 vce
Exam name: CCIE SP Written v4.0
n questions with full explanations
Certification: Cisco Certification
Last updated on Global synchronizing
Verified of 400-201 exam question materials and keys for Cisco certification for client, Real Success Guaranteed with Updated 400-201 pdf dumps vce Materials. 100% PASS CCIE SP Written v4.0 exam Today!
2016 May 400-201 Study Guide Questions:
Q81. In an end-to-end Layer 2 service, which technology provides the capability to detect, verify, isolate, and report faults across a provider network?
A. carrier detect
Q82. Refer to the exhibit.
When a traceroute is performed from a PC behind R2, the next hop on R1 for IPv4 is 10.0.1.2, and for IPv6 it is 2001:DB8:2:2. What is causing thus behavior?
A. GigabitEthernet2/1 has a Level 1-only adjacency. This causes it to be the preferred path for the IPv6 packets.
B. When SPF ran on R2, it calculated two equal paths to R1. It was a coincidence that than the packets choose different paths.
C. Multitopology is enabled on R2, which causes the IPv6 packets to use a different path than the IPv4 packets.
D. 2001:DB8:2::2 is on a Gigabit Ethernet interface. Because its speed is higher than Fast Ethernet, the IS-IS metric is preferred.
Q83. Refer to the exhibit. Which statement is true?
A. This is an inter autonomous unicast route.
B. The BGP MED value is 26.
C. This is an mVPN route.
D. The route target value is 10.1.100.2:3.
E. There is a route reflector in this network.
F. The route did not import this route into the VRF one.
Renovate jk0-019 comptia network+ certification exam:
Q84. Two Tier 2 Service Providers are using a Tier 1 Service Provider for transport. MPLS is required between the Tier 2 Service Providers for label switching. In this CSC solution, which label stack is correct?
A. original IP packet, MPLS CSC transport label, MPLS VPN label, and MPLS Tier 2 transport label
B. original IP packet, MPLS Tier 2 transport label, MPLS VPN label, and MPLS CSC transport label
C. original IP packet, MPLS VPN label, MPLS Tier 2 transport label, and MPLS CSC transport label
D. original IP packet, MPLS Tier 2 transport label, MPLS CSC transport label, and MPLS VPN label
Q85. DRAG DROP
Drag and drop the subslot of the SIP-800 card that is used on Cisco CRS routers on the left to the correct PUM ASIC process on the right.
Q86. Refer to the exhibit. R2 and R3 cannot install IS-IS IPv6 routes. What is the root cause?
A. R2 is missing the metric-style wide command under the IS-IS process.
B. R3 is missing the multi-topology transition command under the IS-IS address-family IPv6 process.
C. R2 is missing the multi-topology command under the IS-IS address-family IPv6 process.
D. R3 is missing the metric-style wide command under the IS-IS process.
Certified comptia network+ certification exam (jk0-019):
Q87. Which are two major changes SyncE offers over traditional Ethernet to make it suitable for clock distribution? (Choose two.)
A. SyncE introduces the concept of “Boundary Clocks” and “Transparent Clocks” improving network scalability and accuracy of clock synchronization.
B. Industry standard that guarantee interoperability, since granular details, such as specific field values are specified.
C. A mandated clock accuracy of 4.6ppm.
D. The ESMC protocol for clock selection, distribution, management, traceability, and failover.
E. High-priority synchronization packets so it can continually adjust its own oscillator.
Q88. Refer to the exhibit. A web server is connected to a switch via two Gigabit Ethernet links. These two links are bundled into a single logical link that provides the aggregate bandwidth of 2 Gbps. The support engineer notices that traffic from the Internet to the web server uses both Gigabit Ethernet links. However, traffic from the web server to the Internet uses only one link.
Which CLI command on the exhibit causes this behavior?
A. lacp port-priority 32768 in interface configuration mode
B. channel-group 5 mode passive
C. lacp port-priority 32768 in global configuration mode
D. port-channel load-balance dst-mac
Q89. Refer to the exhibit.
Why is RC unable to receive prefix 184.108.40.206/32?
A. On RB. neighbor 10.10.12.1 send-community is not configured.
B. On RA, ip bgp-community new-format is not configured.
C. On RB. neighbor 10.10.23.3 send-community is not configured.
D. On RA, neighbor 10.10.12.2 send-community is not configured.
E. On RC. ip bgp-community new-format is not configured.
F. On RB, ip bgp-community new-format is not configured
G. On RB. neighbor 10.10.23.3 next-hop-self is not configured.
Q90. An engineer wants to configure Fast Reroute in the network. Which methodology eliminates RSVP configuration in the network?
A. Enable LDP Fast Synch.
B. Enable IP Fast Reroute.
C. Enable the auto tunnel primary feature.
D. Enable Cisco MPLS TE Fast Reroute.
E. Enable the auto tunnel backup feature.
see more CCIE SP Written v4.0